Knowledgebase: Third Party Applications > BuySAFE
How do I provide authentication data for BuySAFE?
Posted by - NA -, Last modified by Jen Ferraz on 30 March 2011 08:53 PM
The authentication data includes:

buySAFE store authentication data - used to display the buySAFE button

buySAFE seal authentication data - used to display the buySAFE Merchant Seal

This data must be input to the Miva Merchant Administration in the buySAFE Setup Page.

To do this the buySAFE for Miva Merchant Module must already be installed and assigned to your store.

In most cases, the authentication data will be input to Miva Merchant during the installation and assignment of the buySAFE for Miva Merchant Module. If you did not specify the authentication data at that time, you can do so now by using the following steps:

1.Obtain your authentication data from buySAFE from one of the following sources:

From your approval email (Subject: buySAFE Application; Status: Approved; Sender: customersupport@buysafe.com)


2. Go to the buySAFE Setup Page in the Miva Merchant Administration by:

  • Logging in to your Miva Administration
  • Expand your store menus on the far left 
  • Click on System Extension Configuration 
  • Click on the buySAFE for Miva Merchant tab
  • If the buySAFE Registration page is not shown, click on Authentication link 
  • Copy and paste the authentication data as follows: 
    • Seal authentication data = Public Hash 
    • Store authentication data = Service Provider token
(450 vote(s))
This article was helpful
This article was not helpful
Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below. This is required to prevent automated registrations and form submissions.

Help Desk Software by Kayako support.miva.com/supportsuite/index.php?